Home Remodeling · Irondequoit, NY

We open up dated rooms all over Irondequoit

Capes and bungalows near Titus Ave and Culver Rd still carry their original layouts. We open them up room by room, floor by floor.

Call (585) 488-3155 Request an estimate

Irondequoit is full of post-war capes and bungalows between the bay and the lake, most of them still running the layout they were built with in the 1950s. Small rooms, one 5×7 bath, a chopped-up first floor that doesn’t work for how people live now. Whether it’s a living room off Culver Rd or a laundry nook squeezed into a Seabreeze bungalow, we open these rooms up and bring them current, floor to ceiling.

Most of Irondequoit’s housing went up quick after the war, capes and small colonials on narrow lots with one-car garages and a single cramped bathroom. Framing is tight, closets are small, and the layouts weren’t built for modern furniture or open sightlines. Once we open a wall we regularly find galvanized supply lines that have never been touched and block basements that were never properly drained. Any of that gets dealt with as part of the room, not left for later.

What’s included

Tear out dated walls and reframe the opening
Replace subfloor and level transitions between rooms
Run new trim, casing and paint-ready walls throughout
Handle doors, closets and mudroom storage built to fit
Address block basement moisture before finishing the floor above
Swap out old galvanized runs feeding the remodeled space

Notes for Irondequoit homeowners

Capes and bungalows near Titus Ave and Culver Rd still carry their original layouts. We open them up room by room, floor by floor.

Narrow lots off Ridge Rd and near Durand Eastman Park mean limited staging space, so we plan material drops and dumpster placement ahead of time.
Many block basements near Irondequoit Bay take on moisture through the walls, so we address drainage before finishing any room built above one.
Older homes in the bungalow neighborhoods near Seabreeze often still run galvanized supply lines, which we flag if a remodel opens up a wall near plumbing.
Work touching structure, electrical or plumbing typically needs a permit through the Town of Irondequoit, and we schedule inspections into the job timeline.

What to know before remodeling in Irondequoit

The recurring problem in Irondequoit is water and old pipe hiding behind a wall that looks fine from the room side. Block basements near the bay hold moisture, and once a floor above gets opened up, that moisture shows in the subfloor. Galvanized supply lines from the original build are often still in the wall too, corroded and undersized. We check both before we finish anything, so the new room isn’t sitting on a problem we covered up.

One crew runs the job start to finish. We show up when we say, clean up every day, and finish the room paint-ready before we leave. On these narrow Irondequoit lots there’s not room for three trucks and a dumpster spread across the yard, so we plan the work tight. Pricing gets laid out before anything starts, no surprises once the walls are open. Call (585) 488-3155 and we’ll walk the room with you.

What to know before remodeling in Irondequoit

Irondequoit questions

My cape has one 5×7 bath and a cramped hallway off the bedrooms. Can you open that up as part of a whole-room job?

Depends on what’s load-bearing, but a lot of Irondequoit capes have a stud wall between the bath and the hall closet that can come out. We check it during the walkthrough and tell you straight what moves and what stays.

The block basement under my house near the bay gets damp. Does that affect a first-floor remodel?

It can, especially on lots close to Irondequoit Bay where the water table sits high. We check moisture at the sill and subfloor before we finish a floor above it. If water needs handled first, we say so before any drywall goes up.

Do I need a permit from the Town of Irondequoit for this kind of work?

Whole-room remodels that touch walls, electrical or plumbing usually need a permit through the Town of Irondequoit building department. We pull what’s required and schedule inspections around the work so it doesn’t stall the job.